5 - 18
BRAKES - BASE
2. Route the brake hose (1) behind the rear shock (2)
and connect to the caliper (3).
3. Install the wheel and tire assembly. (Refer to 22 -
TIRES/WHEELS - STANDARD PROCEDURE).
4. Lower the vehicle.
5. Fill and bleed the brake system.
• Manual bleeding: (Refer to 5 - BRAKES - STAN-
DARD PROCEDURE).
• Pressure bleeding: (Refer to 5 - BRAKES -
STANDARD PROCEDURE).
BRAKE PADS/SHOES
REMOVAL
FRONT DISC BRAKE PADS
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Drain a small amount of fluid from master cylinder
brake reservoir with a clean suction gun.
4. Bottom the caliper pistons into the caliper by prying
the caliper over.
5. Remove the caliper support spring (2) by prying the
spring out of the holes (3) in the caliper (1).
ZH