Chrysler 2005 Crossfire SRT6 Service Manual page 137

ZH
4. Pivot the joint hub 90° relative to the bearing cage
and remove it from the assembly.
5. Thoroughly clean all the parts.
INSPECTION
1. Inspect the roller tracks in the C/V joint housing (1),
bearing cage (2), and joint hub (4). Inspect the
bearing balls (3) for signs of pitting or wear.
2. If these parts are extremely worn, the entire C/V
joint must be replaced. Smooth areas and tracks
caused by the ball bearings are no reason to
replace the C/V joint.
HALFSHAFTS 3 - 21