Installation - Chrysler 2005 Crossfire SRT6 Service Manual

2 - 40 FRONT SUSPENSION
4. Support the lower control arm with a suitable sup-
porting device. Raise the lower control arm up until
it is almost level.
WARNING: ONLY USE APPROVED CLAMPING
DEVICES AND IF APPROPRIATE ALSO SCREEN
OFF THE DANGER AREA. INSPECT SPECIAL
TOOLS FOR DAMAGE AND FUNCTION. WEAR
SAFETY GLOVES AND EYE PROTECTION.
CAUTION: Risk of injury to hands and fingers from
being trapped or crushed when working on pre-
loaded springs or spring bodies.
5. Using Special Tool 9151 Spring Compressor and
9152 Clamping Plates (1), carefully compress the
front spring.
6. Remove the nuts from the lower control arm
mounting bolts.
7. Carefully remove the lower control arm mounting
bolts from the body.
8. Lower the supporting device and swing the lower
control arm down while holding the front spring.
When enough clearance has been achieved from
the lower control arm and the upper spring perch,
remove the front spring from the vehicle.

INSTALLATION

1. Install the compressed front spring (1) with the rub-
ber mount to the vehicle.
ZH