Jacking And Tire Changing - If Equipped; Preparations For Jacking; Jack And Spare Tire Location; Equipment Removal - Chrysler Pacifica 2021 Owner's Manual

290 IN CASE OF EMERGENCY
JACKING AND TIRE CHANGING —
IF EQUIPPED
WARNING!
Do not attempt to change a tire on the side of

the vehicle close to moving traffic. Pull far
enough off the road to avoid the danger of
being hit when operating the jack or changing
the wheel.
Being under a jacked-up vehicle is dangerous.

The vehicle could slip off the jack and fall on
you. You could be crushed. Never put any part
of your body under a vehicle that is on a jack.
If you need to get under a raised vehicle, take
it to a service center where it can be raised on
a lift.
The jack is designed to be used as a tool for

changing tires only. The jack should not be
used to lift the vehicle for service purposes.
The vehicle should be jacked on a firm level
surface only. Avoid ice or slippery areas.
P F J
REPARATIONS OR ACKING
1. Park the vehicle on a firm, level surface. Avoid
ice or slippery areas.
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic. Pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Place the gear selector into PARK (P).
5. Place the ignition in OFF mode.
6. Block both the front and rear of the wheel
diagonally opposite the jacking position. For
example, if the driver's front wheel is being
changed, block the passenger's rear wheel.
Wheel Blocked
NOTE:
Passengers should not remain in the vehicle when
the vehicle is being lifted or raised.
J A S T L
ACK ND PARE IRE OCATION
The jacking tools, spare tire and portable air
compressor (if equipped) or tire service kit (if
equipped) are stowed behind an access panel on
the left hand side of the vehicle.
Jacking Equipment Location
E R
QUIPMENT EMOVAL
1. Remove the access panel to the jacking
equipment.