Front Head Restraint Removal; Rear Head Restraint Removal; Steering Wheel; Manual Tilt/Telescoping Steering Column - Chrysler 300 2017 Owner's Manual

Hide thumbs Also See for 300 2017:
Table of Contents

Advertisement

Front Head Restraint Removal

To remove the head restraint, raise it up as far
as it can go. Then, push the adjustment button
and the release button at the base of each post
while pulling the head restraint up. To reinstall
the head restraint, put the head restraint posts
into the holes. Then, adjust it to the appropriate
height.
NOTE:
Do not reposition the head restraint 180 degrees
to the incorrect position in an attempt to gain
additional clearance to the back of the head.
WARNING!
• A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head re-
straints in a location outside the occupant
compartment.
• ALL the head restraints MUST be rein-
stalled in the vehicle to properly protect the
occupants. Follow the re-installation in-
structions above prior to operating the ve-
hicle or occupying a seat.

Rear Head Restraint Removal

To remove the center head restraint, push the
adjustment button and the release button while
pulling upward on the whole assembly. To reinstall
the head restraint, put the head restraint posts into
the holes and adjust it to the appropriate height.
WARNING!
• A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head re-
straints in a location outside the occupant
compartment.
• ALL the head restraints MUST be rein-
stalled in the vehicle to properly protect the
occupants. Follow the re-installation in-
structions above prior to operating the ve-
hicle or occupying a seat.

STEERING WHEEL

Manual Tilt/Telescoping Steering
Column
This feature allows you to tilt the steering col-
umn upward or downward. It also allows you to
lengthen or shorten the steering column. The
tilt/telescoping lever is located below the steer-
ing wheel at the end of the steering column.
Tilt/Telescoping Control Handle
To unlock the steering column, pull the lever
downward. To tilt the steering column, move the
steering wheel upward or downward as desired.
To lengthen or shorten the steering column, pull
the steering wheel outward or push it inward as
desired. To lock the steering column in position,
push the lever upward until fully engaged.
WARNING!
Do not adjust the steering column while
driving. Adjusting the steering column while
driving or driving with the steering column
unlocked, could cause the driver to lose
control of the vehicle. Failure to follow this
warning may result in serious injury or death.
39

Advertisement

Table of Contents
loading

Table of Contents