Chrysler 2005 Crossfire SRT6 Service Manual page 2355

ZH
(P0410) SECONDARY AIR INJECTION SYSTEM (CONTINUED)
11.
AIR PUMP FUSE OPEN
Turn the ignition off.
Inspect the 40 amp Air Pump Fuse for an open or high resistance connection.
Is the 40 amp Air Pump Fuse good?
Yes >> Go To 12
No >> Check the Air Pump Relay Output circuit, Relay Control Module, and Air Pump Relay for a short to
ground. Repair as necessary. If OK, replace the Air Pump and Air Pump Fuse. (Refer to 25 - EMIS-
SIONS CONTROL/AIR INJECTION/PUMP - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
12.
CHECK THE AIR PUMP RELAY
With the ignition off.
Reconnect the Air Pump harness connector.
Disconnect the Relay Control Module A and B harness connectors.
Note: Check connectors — Clean/repair as necessary.
Connect a fused jumper wire between pin 2 of the Relay Control Mod-
ule B harness connector and pin 4 of the Relay control Module A har-
ness connector.
Turn the ignition on.
Does the Air Pump run?
Yes >> Replace the Relay Control Module.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the Air Pump Relay Output circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 431