Chrysler 2005 Crossfire SRT6 Service Manual page 2208

9 - 284 ENGINE - ELECTRICAL DIAGNOSTICS
(P0201) FUEL INJECTOR #1 CIRCUIT (CONTINUED)
4.
INJECTOR CONTROL CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM harness connectors.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Injector Control circuit from the Fuel
Injector harness connector to the PCM harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Injector Control circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
5.
INJECTOR CONTROL CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the Injector Control cir-
cuit.
Is the resistance above 100 kohms?
Yes >> Go To 6
No >> Repair the Injector Control circuit for a short to ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH