Chrysler 2005 Crossfire SRT6 Service Manual page 2325

ZH
(P0335) CRANKSHAFT POSITION SENSOR CIRCUIT (CONTINUED)
8.
CKP SENSOR SIGNAL 2 CIRCUIT OPEN
With the ignition off.
Measure the resistance of the CKP Sensor Signal 2 circuit from the
CKP harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the CKP Sensor Signal 2 circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
9.
CKP SENSOR SIGNAL 1 CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the CKP Sensor Signal 1 circuit at the CKP
Sensor harness connector.
Is the voltage below 1.0 volt?
Yes >> Go To 10
No >> Repair the CKP Sensor Signal 1 circuit for a short to volt-
age.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 401
CONTROL MODULE -