Chrysler 2005 Crossfire SRT6 Service Manual page 2322

9 - 398 ENGINE - ELECTRICAL DIAGNOSTICS
(P0335) CRANKSHAFT POSITION SENSOR CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Engine cranking or running.
• Set Condition: No Crankshaft Position (CKP) signal is present during engine cranking and at least 8 Camshaft
Position Sensor (CMP) signals have occurred.
CRANKSHAFT POSITION SENSOR SIGNAL 1 CIRCUIT OPEN
CRANKSHAFT POSITION SENSOR SIGNAL 1 CIRCUIT SHORT TO VOLTAGE
CRANKSHAFT POSITION SENSOR SIGNAL 1 CIRCUIT SHORT TO GROUND
CRANKSHAFT POSITION SENSOR SIGNAL 2 CIRCUIT OPEN
CRANKSHAFT POSITION SENSOR SIGNAL 2 CIRCUIT SHORT TO VOLTAGE
CRANKSHAFT POSITION SENSOR SIGNAL 2 CIRCUIT SHORT TO GROUND
CRANKSHAFT POSITION SENSOR SIGNAL 1 CIRCUIT SHORT TO CRANKSHAFT POSITION SENSOR
SIGNAL 2 CIRCUIT
CRANKSHAFT POSITION SENSOR
POWERTRAIN CONTROL MODULE
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
PRE-DIAGNOSTIC CHECK OUT
Note: Always perform diagnostics with a fully charged battery.
Note: Check connectors — Clean/repair as necessary. Poor pin to
terminal connections can set DTCs.
Note: Check for applicable TSBs related to the problem.
Turn the ignition on.
With the DRB III , read PCM DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors. Repair as necessary.
Perform this procedure prior to symptom diagnosis.
Continue
Go To 2
POSSIBLE CAUSES
ZH