Chrysler 2005 Crossfire SRT6 Service Manual page 2326

9 - 402 ENGINE - ELECTRICAL DIAGNOSTICS
(P0335) CRANKSHAFT POSITION SENSOR CIRCUIT (CONTINUED)
10.
CKP SENSOR SIGNAL 1 CIRCUIT SHORT TO GROUND
Turn the ignition off.
Measure the resistance between ground and the CKP Sensor Signal 1
circuit.
Is the resistance above 100 kohms?
Yes >> Go To 11
No >> Repair the CKP Sensor Signal 1 circuit for a short to
ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
11.
CKP SENSOR SIGNAL 1 CIRCUIT OPEN
With the ignition off.
Measure the resistance of the CKP Sensor Signal 1 circuit from the
CKP harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 12
No >> Repair the CKP Sensor Signal 1 circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH