Chrysler 2005 Crossfire SRT6 Service Manual page 2440

9 - 516 ENGINE - ELECTRICAL DIAGNOSTICS
(P0521) ENGINE OIL SENSOR LEVEL PERFORMANCE (CONTINUED)
17.
5-VOLT SUPPLY CIRCUIT SHORT TO OIL SENSOR SIGNAL CIRCUIT
Turn the ignition off.
Measure the resistance between the Oil Sensor Signal circuit and the
5-Volt Supply circuit at the Oil Sensor harness connector.
Is the resistance above 100 kohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the 5-Volt Supply circuit for a short to the Oil Sen-
sor Signal circuit.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
18.
MEASURE RESISTANCE BETWEEN GROUND AND OIL SENSOR SIGNAL CIRCUIT
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance between ground and the Oil Sensor Signal cir-
cuit at the Oil Sensor harness connector.
Is the resistance above 100 kohms?
Yes >> Go To 19
No >> Repair the MAP Sensor Signal circuit for a short to
ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
CONTROL MODULE -
ZH