ZH
(P0445) EVAP PURGE SOLENOID CIRCUIT (CONTINUED)
4.
BYPASS THE PCM
Turn the ignition off.
Reconnect the Evap Purge Solenoid harness connector.
Disconnect the PCM C5 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Connect a fused jumper wire between ground and the Evap Purge
Solenoid Control circuit at the PCM C5 harness connector.
Does the Evap Purge Solenoid produce an audible click?
Yes
>> Go To 5
No
>> Go To 6
5.
EVAP PURGE SOLENOID CONTROL CIRCUIT CURRENT FLOW
Turn the ignition off.
Replace the EVAP Purge Solenoid. (Refer to 25 - EMISSIONS CON-
TROL/EVAPORATIVE
REMOVAL).
Turn the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
Note: The engine controls must go into closed loop and purge
control must be active for at least 2 minutes.
With the DRB III , read the PCM DTCs.
Did this DTC set again?
Yes
>> Replace and program the Powertrain Control Module. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/POWERTRAIN CONTROL MODULE - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No
>> Test Complete.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
EMISSIONS/EVAP/PURGE
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 457
SOLENOID
-