Chrysler 2005 Crossfire SRT6 Service Manual page 2340

9 - 416 ENGINE - ELECTRICAL DIAGNOSTICS
(P0341) CAMSHAFT POSITION SENSOR PERFORMANCE (CONTINUED)
8.
CMP SENSOR SIGNAL CIRCUIT SHORT TO SENSOR GROUND CIRCUIT
With the ignition off.
Measure the resistance between the CMP Signal circuit and the Sen-
sor Ground circuit at the CMP Sensor harness connector.
Is the resistance above 100 kohms?
Yes >> Go To 9
No >> Repair the CMP Sensor Signal circuit for a short to the
Sensor Ground circuit.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
9.
CAMSHAFT POSITION SENSOR
With the ignition off.
Replace the Camshaft Position Sensor. (Refer to 8 - ELECTRICAL/IG-
NITION CONTROL/CAMSHAFT POSITION SENSOR - REMOVAL).
Attempt to start the engine.
With the DRB III , read engine DTCs.
Did this DTC set again?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Test Complete.
CONTROL MODULE -
ZH