Chrysler 2005 Crossfire SRT6 Service Manual page 2230

9 - 306 ENGINE - ELECTRICAL DIAGNOSTICS
(P0211) THROTTLE ACTUATOR STUCK (CONTINUED)
7.
THROTTLE CONTROL MOTOR 1 CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the Throttle Control
Motor 1 circuit.
Is the resistance above 100 kohms?
Yes >> Go To 8
No >> Repair the Throttle Control Motor 1 circuit for a short to
ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
8.
THROTTLE CONTROL MOTOR 2 CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the Throttle Control
Motor 2 circuit.
Is the resistance above 100 kohms?
Yes >> Go To 9
No >> Repair the Throttle Control Motor 2 circuit for a short to
ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
9.
PCM
Note: Before continuing, check the PCM C1 harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and
Ground circuits.
If there are no possible causes remaining, view repair.
Repair
Replace and program the Powertrain Control Module. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/POWERTRAIN CONTROL MODULE - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH