Chrysler 2005 Crossfire SRT6 Service Manual page 2498

9 - 574 ENGINE - ELECTRICAL DIAGNOSTICS
(P0600) NO TRANSMISSION BUS MESSAGE (CONTINUED)
3.
PCM AND SKREEM CAN C BUS TERMINATION
Turn the ignition off.
Measure the resistance of the PCM CAN C BUS termination by back-
probing between the CAN C BUS (+) circuit and the CAN C BUS (-)
circuit at the PCM C4 harness connector.
Is the resistance between 50 and 70 ohms?
Yes >> Go To 11
No >> Go To 4
4.
PCM CAN C BUS TERMINATION
With the ignition off.
Disconnect the PCM C4 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the SKREEM CAN C BUS termination by
backprobing between the CAN C BUS (+) circuit and the CAN C BUS
(-) circuit at the PCM C4 harness connector.
Is the SKREEM CAN C BUS termination resistance between 110
and 130 ohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Go To 5
CONTROL MODULE -
ZH