Chrysler 2005 Crossfire SRT6 Service Manual page 2341

ZH
(P0341) CAMSHAFT POSITION SENSOR PERFORMANCE (CONTINUED)
10.
INTERMITTENT CMP SIGNAL
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND
IN A DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS
NEAR THE PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE
CLOTHING.
Start the engine.
Monitor the DRB III for DTCs.
Gently tap on the Camshaft Position Sensor and wiggle the Sensor
harness connector.
Inspect the CMP Sensor harness connector, PCM C3 harness connec-
tor, CMP Sensor connector, and PCM connector for loose, bent, cor-
roded, or pushed out pins/terminals.
Inspect the related wire harness and the splices in the CMP circuits.
With the DRB III , read engine DTCs.
Did this DTC set again?
Yes >> Repair the wiring/connector concerns as needed or replace the Camshaft Position Sensor. (Refer to 8 -
ELECTRICAL/IGNITION CONTROL/CAMSHAFT POSITION SENSOR - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Go To 11
11.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Note: Check for any Technical Service Bulletins that may apply.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 417