Chrysler 2005 Crossfire SRT6 Service Manual page 2338

9 - 414 ENGINE - ELECTRICAL DIAGNOSTICS
(P0341) CAMSHAFT POSITION SENSOR PERFORMANCE (CONTINUED)
4.
SENSOR GROUND CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Sensor Ground circuit from the CMP
Sensor harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Sensor Ground circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
5.
CMP SIGNAL CIRCUIT SHORT TO VOLTAGE
Turn the ignition on.
Measure the voltage of the CMP Signal circuit at the CMP Sensor har-
ness connector.
Is the voltage below 1.0 volt?
Yes >> Go To 6
No >> Repair the CMP Signal circuit for a short to voltage.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH