Chrysler 2005 Crossfire SRT6 Service Manual page 2497

ZH
(P0600) NO TRANSMISSION BUS MESSAGE (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on.
• Set Condition: This DTC is set when a CAN ID is not received in the required time from the Transmission
Control Module (TCM).
CAN C BUS (+)/(-) CIRCUIT OPEN
CAN C BUS (+)/(-) CIRCUIT SHORT TO GROUND
CAN C BUS (+)/(-) CIRCUIT SHORT TO VOLTAGE
TRANSMISSION CONTROL MODULE
SENTRY KEY REMOTE ENTRY MODULE
POWERTRAIN CONTROL MODULE
For a complete Electronic Control Module Circuit Diagram, (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
CHECK TO SEE IF TCM DTCS ARE PRESENT
Turn ignition on.
With the DRB III , read TCM DTCs.
Are any performance or BUS related DTCs present?
Yes >> Repair all TCM DTCs before proceeding.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Go To 2
2.
VERIFY DTCS
With the ignition on.
With the DRB III , erase PCM DTCs.
Turn the ignition off, then back on.
Monitor the DRB III for this DTC.
Did the DTC, (P0600) NO TRANSMISSION BUS MESSAGE, set
again?
Yes >> Go To 3
No >> Go To 12
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 573
POSSIBLE CAUSES