Chrysler 2005 Crossfire SRT6 Service Manual page 2337

ZH
(P0341) CAMSHAFT POSITION SENSOR PERFORMANCE (CONTINUED)
2.
CHECK FOR CURRENT DTC
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND
IN A DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS
NEAR THE PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE
CLOTHING.
Note: If the PCM detects and stores a DTC, the PCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for a DTC.
Turn the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to set.
With the DRB III , read PCM DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 10
3.
FUSED ENGINE CONTROL RELAY OUTPUT CIRCUIT OPEN
Turn the ignition off.
Disconnect the CMP Sensor harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused Engine Control Relay Output circuit
at the CMP Sensor harness connector.
Is the voltage above 10 volts?
Yes >> Go To 4
No >> Repair the Fused Engine Control Relay Output circuit for
an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 413