Chrysler 2005 Crossfire SRT6 Service Manual page 2486

9 - 562 ENGINE - ELECTRICAL DIAGNOSTICS
(P0575) SPEED CONTROL SWITCH INPUT CIRCUIT (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: If the PCM detects and stores a DTC, the PCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for an active DTC.
Turn the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
With the DRB III , read PCM DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 7
3.
PCM
Turn the ignition off.
Disconnect the PCM C4 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Speed Control Off Signal circuit at the
PCM C4 harness connector.
Is the voltage above 10 volts?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 5.
No >> Go To 4
CONTROL MODULE -
ZH