Chrysler 2005 Crossfire SRT6 Service Manual page 2336

9 - 412 ENGINE - ELECTRICAL DIAGNOSTICS
(P0341) CAMSHAFT POSITION SENSOR PERFORMANCE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Engine cranking/running. Battery voltage greater than 10 volts.
• Set Condition: At least 5 seconds or 2.5 engine revolutions have elapsed with Crankshaft Position Sensor
(CKP) Signals present but no Camshaft Position (CMP) Sensor Signal. One Trip Fault.
INTERMITTENT CAMSHAFT POSITION (CMP) SENSOR SIGNAL (CMP)
FUSED ENGINE CONTROL RELAY OUTPUT CIRCUIT OPEN
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT SHORT TO GROUND
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT OPEN
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT SHORT TO SENSOR GROUND CIRCUIT
SENSOR GROUND CIRCUIT OPEN
CAMSHAFT POSITION SENSOR
POWERTRAIN CONTROL MODULE
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
PRE-DIAGNOSTIC CHECK OUT
Note: Always perform diagnostics with a fully charged battery.
Note: Check connectors — Clean/repair as necessary. Poor pin to
terminal connections can set DTCs.
Note: Check for applicable TSBs related to the problem.
Turn the ignition on.
With the DRB III , read PCM DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors. Repair as necessary.
Perform this procedure prior to symptom diagnosis.
Continue
Go To 2
POSSIBLE CAUSES
ZH