Chrysler 2005 Crossfire SRT6 Service Manual page 2329

ZH
(P0341) CAMSHAFT POSITION TIMING OVER-RETARDED (CONTINUED)
When Monitored and Set Condition
• When Monitored: Engine cranking and engine running
• Set Condition: If the Camshaft Position Signal (angular variation) is less than 15° of the Crankshaft Position
Signal, this DTC is set.
CAMSHAFT POSITION SENSOR WIRE HARNESS
TONE WHEEL/PULSE RING
CAMSHAFT POSITION SENSOR
TIMING CHAIN
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
PRE-DIAGNOSTIC CHECK OUT
Note: Always perform diagnostics with a fully charged battery.
Note: Check connectors — Clean/repair as necessary. Poor pin to
terminal connections can set DTCs.
Note: Check for applicable TSBs related to the problem.
Turn the ignition on.
With the DRB III , read PCM DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors. Repair as necessary.
Perform this procedure prior to symptom diagnosis.
Continue
Go To 2
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 405
POSSIBLE CAUSES