Chrysler 2005 Crossfire SRT6 Service Manual page 2382

9 - 458 ENGINE - ELECTRICAL DIAGNOSTICS
(P0445) EVAP PURGE SOLENOID CIRCUIT (CONTINUED)
6.
EVAP PURGE SOLENOID CONTROL CIRCUIT PROBLEM
Turn the ignition off.
Disconnect the Evap Purge Solenoid harness connector.
Check the Evap Purge Solenoid Control circuit for a short to voltage,
short to ground, or an open.
Was a circuit problem found?
Yes >> Repair the Evap Purge Solenoid Control circuit for the
problem found.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Replace the Evap Purge Solenoid. (Refer to 25 - EMIS-
SIONS CONTROL/EVAPORATIVE
PURGE SOLENOID - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
7.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using
the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
EMISSIONS/EVAP/
ZH