Chrysler 2005 Crossfire SRT6 Service Manual page 2324

9 - 400 ENGINE - ELECTRICAL DIAGNOSTICS
(P0335) CRANKSHAFT POSITION SENSOR CIRCUIT (CONTINUED)
5.
CKP SENSOR SIGNAL 2 CIRCUIT VOLTAGE
With the ignition on.
Measure the voltage of the CKP Sensor Signal 2 circuit at the CKP
Sensor harness connector.
Is the voltage between 2.2 and 2.7 volts?
Yes >> Go To 13
No >> Go To 6
6.
CKP SENSOR SIGNAL 2 CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the PCM C3 harness.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the CKP Sensor Signal 2 circuit at the CKP
Sensor harness.
Is the voltage below 1.0 volt?
Yes >> Go To 7
No >> Repair the CKP Sensor Signal 2 circuit for a short to volt-
age.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
7.
CKP SENSOR SIGNAL 2 CIRCUIT SHORT TO GROUND
Turn the ignition off.
Measure the resistance between ground and the CKP Sensor Signal 2
circuit.
Is the resistance above 100 kohms?
Yes >> Go To 8
No >> Repair the CKP Sensor Ground circuit for a short to
ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH