Chrysler 2005 Crossfire SRT6 Service Manual page 2327

ZH
(P0335) CRANKSHAFT POSITION SENSOR CIRCUIT (CONTINUED)
12.
CKP SENSOR SIGNAL 1 CIRCUIT SHORT TO CKP SENSOR SIGNAL 2 CIRCUIT
With the ignition off.
Measure the resistance between the CKP Sensor Signal 1 circuit and
the CKP Sensor Signal 2 circuit at the CKP Sensor harness connector.
Is the resistance above 100 kohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the CKP Sensor Signal 1 circuit for a short to the
CKP Sensor Signal 2 circuit.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
13.
TONE WHEEL/PULSE RING INSPECTION
Turn the ignition off.
Remove the Crankshaft Position Sensor.
Inspect the Tone Wheel/Pulse Ring for damage, foreign material, or excessive movement.
Were any problems found?
Yes >> Repair or replace the Tone Wheel/Pulse Ring as necessary. (Refer to 9 - ENGINE/ENGINE BLOCK/
FLEX PLATE - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Replace the Crankshaft Position Sensor. (Refer to 14 - FUEL SYSTEM/FUEL INJECTION/CRANK-
SHAFT POSITION SENSOR - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
14.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Note: Check for any Technical Service Bulletins that may apply.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and/or open circuits.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 403
CONTROL MODULE -