ZH
(P0600) NO TRANSMISSION BUS MESSAGE (CONTINUED)
5.
SKREEM TERMINATION
With the ignition off.
Measure the resistance of the SKREEM CAN C BUS termination by
backprobing between the CAN C BUS (+) circuit and the CAN C BUS
(-) circuit at the SKREEM C2 harness connector.
Is the resistance between 110 and 130 ohms?
Yes
>> Go To 6
No
>> Replace the Sentry Key Remote Entry Module. (Refer to 8
- ELECTRICAL/ELECTRONIC CONTROL MODULES/EN-
TRY MODULE - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
6.
CAN C BUS (-) CIRCUIT OPEN
With the ignition off.
Disconnect the SKREEM C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the CAN C BUS (-) circuit from the
SKREEM C2 harness connector to the PCM C4 harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Go To 7
No
>> Repair the CAN C BUS (-) circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 575