Chrysler 2005 Crossfire SRT6 Service Manual page 2258

9 - 334 ENGINE - ELECTRICAL DIAGNOSTICS
(P023A) CHARGE AIR COOLER CIRCULATION PUMP CONTROL CIRCUIT (CONTINUED)
4.
MEASURE VOLTAGE OF CHARGE AIR COOLER CIRCULATION PUMP CONTROL CIRCUIT WITH
IGNITION ON
Turn the ignition on.
Measure the voltage of the Charge Air Cooler Circulation Pump Con-
trol circuit at the PCM C4 harness connector.
Is the voltage above 10 volts?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform the POWERTRAIN VERIFICATION TEST - VER
2.
No >> Go To 5
5.
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
Turn the ignition off.
Disconnect the Pulse Module E harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
Pulse Module E harness connector.
Is the voltage above 10 volts?
Yes >> Go To 6
No >> Repair the Fused Ignition Switch Output circuit for an
open.
Perform the POWERTRAIN VERIFICATION TEST - VER
2.
CONTROL MODULE -
ZH