Chrysler 2005 Crossfire SRT6 Service Manual page 2471

ZH
(P0521) ENGINE OIL SENSOR WATER CONTAMINATION (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the engine running.
• Set Condition: Anytime the Powertrain Control Module (PCM) senses the Oil Quality value is above 4.0.
• Note: The engine oil must be changed before this test can be accurately conducted.
WATER IN THE OIL
CONTAMINATED OIL
OIL SENSOR SIGNAL CIRCUIT OPEN
OIL SENSOR SIGNAL CIRCUIT SHORT TO GROUND
OIL SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE
5-VOLT SUPPLY CIRCUIT OPEN
5-VOLT SUPPLY CIRCUIT SHORT TO GROUND
5-VOLT SUPPLY CIRCUIT SHORT TO VOLTAGE
5-VOLT SUPPLY CIRCUIT SHORT TO SENSOR GROUND CIRCUIT
OIL SENSOR SIGNAL CIRCUIT SHORT TO SENSOR GROUND CIRCUIT
OIL SENSOR SIGNAL CIRCUIT SHORT TO 5-VOLT SUPPLY CIRCUIT
SENSOR GROUND CIRCUIT OPEN
MANIFOLD ABSOLUTE PRESSURE SENSOR
ENGINE OIL SENSOR
POWERTRAIN CONTROL MODULE
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
CHECK FOR CURRENT DTC
Turn the ignition on.
With the DRB III , read PCM DTCs.
Is this DTC present?
Yes >> For complete diagnosis of this DTC, refer to (P0521)
ENGINE OIL SENSOR QUALITY PERFORMANCE.
No >> Go To 2
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 547
POSSIBLE CAUSES