Chrysler 2005 Crossfire SRT6 Service Manual page 2487

ZH
(P0575) SPEED CONTROL SWITCH INPUT CIRCUIT (CONTINUED)
4.
SPEED CONTROL OFF SIGNAL CIRCUIT SHORT TO GROUND
Turn the ignition off.
Disconnect the Speed Control Switch harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance between ground and the Speed Control Off
Signal circuit.
Is the resistance above 100 kohms?
Yes >> Go To 5
No >> Repair the Speed Control Off Signal circuit for a short to
ground.
Perform POWERTRAIN VERIFICATION TEST - VER 5.
5.
SPEED CONTROL OFF SIGNAL CIRCUIT OPEN
With the ignition off.
Measure the resistance of the Speed Control Off Signal circuit from
the PCM C4 harness connector to the Speed Control Switch harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 6
No >> Repair the Speed Control Off Signal circuit open.
Perform POWERTRAIN VERIFICATION TEST - VER 5.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 563