Chrysler 2005 Crossfire SRT6 Service Manual page 2209

ZH
(P0201) FUEL INJECTOR #1 CIRCUIT (CONTINUED)
6.
FUSED ENGINE CONTROL RELAY OUTPUT CIRCUIT SHORT TO INJECTOR CONTROL CIRCUIT
With the ignition off.
Measure the resistance between the Fused Engine Control Relay Out-
put circuit and the Injector Control circuit at the Fuel Injector harness
connector.
Is the resistance above 100 kohms?
Yes >> Go To 7
No >> Repair the Injector Control circuit for a short to the Fused
Engine Control Relay Output circuit.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
7.
FUEL INJECTOR
Note: The fuel injectors are polarity sensitive. If a reading is not
obtained with the meter leads connected one way, reverse the
test leads and take another reading.
With the ignition off.
Measure the resistance of the Fuel Injector.
Is the resistance between 12 and 18 ohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Replace the Fuel Injector. (Refer to 14 - FUEL SYSTEM/
FUEL INJECTION/FUEL INJECTOR - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
8.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using
the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 285
CONTROL MODULE -