Chrysler 2005 Crossfire SRT6 Service Manual page 2228

9 - 304 ENGINE - ELECTRICAL DIAGNOSTICS
(P0211) THROTTLE ACTUATOR STUCK (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: The PCM tests the Electronic Throttle Control (ETC) Motor
by opening and closing the Throttle Plate before starting the
engine. If the Throttle Plate does not open during this test, this
DTC will set.
Note: If the PCM detects and stores a DTC, the PCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for an active DTC.
Turn the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to set.
With the DRB III , read PCM DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 10
3.
THROTTLE PLATE STUCK OPEN
Note: The PCM tests the ETC Motor by opening and closing the Throttle Plate before starting the engine. If
the Throttle Plate does not open and return to the closed position during this test, this DTC will set.
Turn the ignition off.
Remove the Air Cleaner Housing. (Refer to 9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING -
REMOVAL).
Remove the MAF from the Throttle Body. (Refer to 14 - FUEL SYSTEM/FUEL INJECTION/MANIFOLD AIR FLOW
(MAF) SENSOR - REMOVAL).
Check for any signs of a foreign material causing the Throttle to remain open.
Manually open and close the throttle plate using your hands.
Does the Throttle Plate move?
Yes >> Go To 4
No >> Remove the debris if possible or replace the Throttle Body. (Refer to 14 - FUEL SYSTEM/FUEL INJEC-
TION/THROTTLE BODY - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH