Chrysler 2005 Crossfire SRT6 Service Manual page 2495

ZH
(P0600) NO CAN MESSAGE FROM CAB MODULE (CONTINUED)
11.
CAN C BUS (-) CIRCUIT OPEN FROM CAB TO PCM
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the CAN C BUS (-) circuit from the CAB
harness connector to the PCM C4 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Repair the CAN C BUS (+) circuit for an open between the
PCM C4 harness and the CAB harness connector.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the CAN C BUS (-) circuit for an open between the
PCM C4 harness and the CAB harness connector.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
12.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Note: Check for any Technical Service Bulletins that may apply.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and/or open circuits.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST VER.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 571