Chrysler 2005 Crossfire SRT6 Service Manual page 2352

9 - 428 ENGINE - ELECTRICAL DIAGNOSTICS
(P0410) SECONDARY AIR INJECTION SYSTEM (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: If the PCM detects and stores a DTC, the PCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for a DTC.
Turn the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
With the DRB III , read PCM DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 13
3.
INSPECT THE SECONDARY AIR INJECTION SYSTEM
Turn the ignition off.
Inspect the Air Pump system for the following:
• Damage to any component.
• Cracked, missing, misrouted, or plugged vacuum lines.
• Damaged or misrouted electrical wires.
Did you find any of the above conditions?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Go To 4
4.
OPERATE THE AIR PUMP
Turn the ignition on.
With the DRB III , actuate the AIRPUMP SWITCHOVER.
Does the Air Pump run?
Yes >> Go To 5
No >> Go To 8
ZH