TOHATSU MD 70-90C2 Service Manual page 238

Cowl, Bracket and PTT Unit
6. Attach reverse gas passage in the drive shaft housing
facing "UP" mark of reverse gas passage q upward and
"F" mark forward.
Install idle exhaust port grommet w to exhaust housing.
7.
8. Check that drive shaft housing dowel pin is placed and
secured to engine base properly.
Check that water pipe is at joint of engine base.
9. Install engine base to drive shaft housing by tightening
installation bolts to specified torque.
Engine Base Bolts :
13 N · m (9 lb · ft) [1.3 kgf · m]
Tighten M6 bolt in the area shown with the arrow
to specified torque.
M6 Bolt :
6 N · m (4 lb · ft) [0.6 kgf · m]
7-22
q
72
w
TLDI 75/90C2 2010