Adjustment Of Shift Cable - TOHATSU MD 70-90C2 Service Manual

Maintenance
7. Attach cable joint, washer and "R" shaped pin to advancer
arm.
8. Check if throttle control can be made smoothly. If
necessary, readjust by following the steps 1 to 7.
Make sure the cable pushes the throttle arm against the
stop at WOT in forward against.
TPS error occurs if advancer arm does not
touch the full close stopper when remote
control lever is at throttle full close
position.
Refer to Chapter "10" for resetting the
error.

2) Adjustment of Shift Cable

Loosen lock nut 1.
1.
Remove "R" shaped pin 2 and washer 3.
2.
Remove cable joint 4 from shift arm 5.
3.
4. Set shift lever to neutral position (N).
5. Set remote control lever to neutral position (N).
6. Adjust cable joint screw-in length so that the pin of shift
arm is aligned with the hole of cable joint.
Adjust cable and cable joint screw-in length
a to 10mm (0.39m) or over.
7. Attach cable joint, washer and "R" shaped pin to advancer
arm.
8. Check if shift control can be made smoothly. If necessary,
readjust by following the steps 1 to 7.
3-14
CAUTION
CAUTION
2
5
R
a
N
4
3
1
N
N
R
F
F
N
TLDI 75/90C2 2010