Installation Of Crank Shaft - TOHATSU MD 70-90C2 Service Manual

Fuel System (TLDI)
Apply two stroke engine oil to periphery of oil seal 5,
2.
lithium grease to the lip area, and install it into
compressor housing by using a press.
Driver Rod 1 :
P/N. 3AC-99702-0
Oil Seal Attachment 4 :
P/N. 3T1-99820-0
Be careful of orientation of oil seal when it is
installed.
2st OIL
2st
LIT
LIT

9) Installation of Crank Shaft

Install crank shaft 1 to the housing 2, and fix the crank
1.
shaft at its lower end by using a vice.
Attach collar 3, O ring 4, and driven pulley 5, and
2.
tighten nut 6 to the specified torque.
Driven Pulley Nut 6
50N·m (36 lb·ft) [5.0kgf·m]
Be careful not to damage the crank pin
area 7 when fixing crank shaft using a
vice.
2st OIL
2st
4-36
CAUTION
1
4
⑤ Oil seal
Do not reuse
4
1
5
LIT 2st
LIT 2st OIL
6
5
2st
2st OIL
3
2
7
TLDI 75/90C2 2010