Service Information; Service Data; Load Limit Of Boat; Installation Dimensions - TOHATSU MD 70-90C2 Service Manual

Rigging
r/min

1. Service Information

The persons who perform the rigging should take sufficient care for prevention of damages to himself or herself and the
products, prevention of fire, and ventilation of the shop.
The persons who operate the boat equipped with this product for test run should read the operating instructions of the
outboard, and be familiar with the operating procedure.

2. Service Data

1) Load Limit of Boat

Do not over-power the boat and take care not to over-load the engine. Boat manufacturers specify the maximum
allowable engine power and complement of their boats in accordance with certain standards and show the data on
the plate attached to the boats. For unknown matters, if any, inquire of the dealer or manufacturer of the boat.
Never use boat equipped with an outboard motor(s) that outputs power exceeding the
maximum allowable limit specified by the manufacturer of the boat, or the following
problems can occur.
· The boat can go out of control.
· The buoyancy property of the boat varies from the designed value if the boat is
overloaded especially at the transom.
· The boat may crack or be damaged around the transom.
Over-powering boats can cause serious injury, fatal accident and/or serious damages to
the hull.

2) Installation Dimensions

Minimum Allowable Size of Transom Opening :
Single Machine Installation (Remove Control Models)
848 mm (33.39 in.)
Twin Machine Installation
Minimum center-to-center distance for twin installation : b
700 - 890 mm (27.55 - 35.04 in.)
Installation of an outboard motor(s) at higher
position(s) can cause engine overheating and/or
damages to gear case components.
10-2
WARNING
a
1,518mm (59.76 in.)
a
a
b
TLDI 75/90C2 2010