TOHATSU MD 70-90C2 Service Manual page 334

Rigging
r/min
8. Adjust screw in length of cable joint so that cable joint hole
aligns with shift arm and advancer arm pins, lock the joint
with nut, and then, set it on the arm pin and secure with
"R" pin and washer.
Put the cable in cable clip groove, and then secure it by
using cord clamp.
Check that shifting control lever forward (F) by
approximately 32 degrees, where it is stopped
once, makes the gear engage, and fully shifting
the lever makes throttle valve fully open, and
then, check that shifting the lever reverse (R) by
approximately 32 degrees, where it is stopped
once, makes the gear engage, and fully shifting
the lever makes throttle valve fully open.
Then, check that, when control lever is returned to
neutral position (N), advancer arm of the outboard
motor side is at full close position. Since throttle
position sensor (TPS) operates incorrectly if
advancer arm does not contact with full close
stopper, readjust cable joint position at outboard
motor side and reinstall it if the valve is not fully
closed in this case.
9. Run cord ass'y, hose and control cables through their
specified holes of the cord grommet, secure them using
cord clamps, and attach hose clamp to secure the cord
grommet as shown.
Before securing hose clamp, check that the hoses
and cords are put surely in their specified holes.
If they are put in the holes improperly, the hoses
may collapse, and cord clamp cannot be attached
to the lower cowl.
a Battery Cables
b Fuel Hose
c Cord Ass'y (B) (Remote Control Harness)
d Throttle Cable
e Shift Cable
f Meter Cord Ass'y
g Trim Sensor, for extension (optional part)
10-12
c
e
a
g
d
b
f
TLDI 75/90C2 2010