TOHATSU MD 70-90C2 Service Manual page 245

5. Attach bushings to PTT (upper) and swivel bracket.
6. Extend tilt rod until PTT tilt rod hole aligns with swivel
bracket hole.
Connecting electrical wires to battery
terminals may cause sparks to occur. Do
not perform this work when flammable
matter is near the working area.
· Connect blue lead to battery positive terminal
to extend tilt rod.
· Connect green lead to battery positive terminal
to retract tilt rod.
Install cylinder pin upper 4 and secure with bolt 5.
7.
8. Run PTT and trim sensor leads through clamp bracket
hole and collect them using wire clamp and tie strap.
3
TLDI 75/90C2 2010
WARNING
1
2
reen
OBM OBM OBM
OBM
5
4
OBM OBM OBM
OBM
OBM OBM OBM
OBM
Blue
Blue
Green
OBM OBM OBM
OBM
7-29
7