Connection Of Fuel Hose; Filling Fuel System; Filling Oil Tank - TOHATSU MD 70-90C2 Service Manual

5) Connection of Fuel Hose

Secure remote fuel hose to the fitting by using hose tie.
: Remove cap 2 from tip of hose nipple 1 of fuel hose.
A
B
: Use hose tie to secure remote fuel hose.
For fuel hose, use independent fuel line / fuel tank
pick up for individual engines, and use fuel hose
of minimum inner diameter of 8mm (0.315 in, 5/16
in).

6) Filling Fuel System

Fill the fuel system as described below before initially starting
new engine, after engine exhausted fuel, or after draining fuel
from engine.
1. Squeeze priming bulb of fuel hose until it becomes stiff.
2. Set key switch to "ON" position for three seconds to
operate electric fuel pump.
3. Return key switch to "OFF" position and squeeze priming
bulb again until it becomes stiff. Set key switch to "ON"
position for three seconds again. Repeat these steps until
primary bulb of fuel hose becomes stiff.

7) Filling Oil Tank

Note: Oil tank capacity is 4.3L (1.14gal).
Remove top cowl, and then turn oil tank cap 1 counter
1.
clockwise to remove.
2. Pour specified quantity of engine oil into oil tank. Do not
overfill. Oil level should be below filler neck a.
3. Put oil tank cap on the tank and tighten. Reinstall top cowl.
a : Oil Upper Level 4.3L (1.14gal)
TLDI 75/90C2 2010
A
1
B
1
a
2
10
10-7