TOHATSU MD 70-90C2 Service Manual page 242

Cowl, Bracket and PTT Unit
Remove tie wrap 3 and clamp 4 and draw PTT wires 5
2.
to the direction shown.
3. Remove upper cylinder piston stopper washer and bolt,
and remove cylinder pin 6.
Cylinder pin can be pulled out easier while
adjusting trim rod length.
4. Operate PTT unit, to retract tilt rod and trim rods.
· Check that tilt stopper locks the outboard
motor securely.
· Connecting electrical wires to battery
terminals may cause sparks to occur. Do
not perform this work when inflammable
matter is near the working area.
Remove "C" ring 7 and cylinder pin lower 8, and remove
5.
PTT unit.
When pulling out cylinder pin lower 8, use
a hand to hold PTT and another hand to
pull out pin.
7-26
WARNING
CAUTION
3
4
5
6
8
Green
7
Blue
TLDI 75/90C2 2010