TOHATSU MD 70-90C2 Service Manual page 333

Screw cable joint 1 on the tip of remote control cable by
4.
approximately 10mm. Open the cut of grommet and run
meter cord ass'y and cord ass'y B attached to remote
control box from front of lower motor cover. Then, run two
remote control cables.
The screw-in distance of cable joint, 10 mm, is
equivalent to approximately 9 threads.
5. Shift cable is the one of which tip is moved when remote
control lever is set to forward (F) side until it stops once
(approx. 32 degrees).
6. Set remote control lever to neutral (N), and check that
neutral throttling lever is at full close position.
7. Set advancer arm to full close position.
Check that advancer arm 1 is surely in contact
with full close side stopper 2.
TLDI 75/90C2 2010
1
Approximately 10 mm
Full open
1
Full close
Neutral
Throttling Lever
2
10
10-11