TOHATSU MD 70-90C2 Service Manual page 254

Cowl, Bracket and PTT Unit
Attach new O ring 4, valve pin 5 and valve seat ass'y 6
5.
to tilt cylinder.
Install gear pump 7.
6.
Gear Pump Installation Bolts :
9 N · m (7 lb · ft) [0.9 kgf · m]
7. Put O ring on the reservoir cap.
Install reservoir 8, and put O ring on the gear pump.
8.
Reservoir Mount Bolts :
5 N · m (4 lb · ft) [0.5 kgf · m]
Put PTT fluid in the tilt cylinder through hole a to a proper
9.
level.
Install tilt piston to cylinder, and tighten tilt rod guide 9 to
10.
specified torque.
· When installing, check that tilt rod is
fully extended.
· After installing tilt piston, do not push tilt
rod. Doing so will cause fluid to spurt.
Tilt Rod Guide 9 :
130 N · m (94 lb · ft) [13.0 kgf · m]
Trim Rod Guide Wrench 0 :
P/N. 3C8-72791-1
7-38
CAUTION
4
4
4 8
9
5
6
7
e
0
TLDI 75/90C2 2010