TOHATSU MD 70-90C2 Service Manual page 140

Power Unit
11. Disconnect overheat sensor connector located on the
cylinder block while pushing lock of the connector.
12. Disconnect ignition coil connector while pulling lock of the
connector. Repeat this step for four cylinders.
13. Disconnect cord ass'y from terminal.
Remove ignition coil #1 lower side installation bolt, and
then, disconnect grounding wire.
Note that grounding wire of cord ass'y is secured
together.
14. Loosen band that secures cord ass'y, and then, remove cord
ass'y from power unit.
• Note that grounding wire of cord ass'y is secured
together.
• Refer to "Electrical Wiring Assembling Instruction
Diagrams 1 and 2" in Chapter 11.
Removing Ignition Coils
1. Loosen mounting bolt of ignition coils #1, #2 and #3, and
remove the coils.
Earth wire of cord ass'y and other wires are
secured together by #1 coil lower bolts.
5-24 TLDI 75/90C2 2010