Connect The Projector To An Optional Uninterrupted Power Supply; Connect Sources And Turn The Projector On - Christie CP4230 User Manual

2.16 Connect the Projector to an Optional Uninterrupted Power Supply

A UPS allows the projector head electronics to remain operable during a power failure.
It is recommended that you install a 200-240VAC UPS in-line between the LPS and the projector. To connect
the projector to a UPS, unplug the LVPS input from the main power and then connect it to the UPS input
socket.
WARNING

2.17 Connect Sources and Turn the Projector On

After you install the lamp, you can connect external cinema servers and sources. Before you ignite the lamp for
the first time, use this procedure to ensure successful communication with input devices.
1. Assign the projector a unique IP address and enter a baud rate:
• Tap Menu > Administrator Setup > Communications Configuration.
• Enter the IP address for the projector in the IP Address field.
• Select a baud rate for the input device in the Serial Speed (Baud) list.
2. Enter lamp information:
• Tap Menu > Advanced Setup > Lamp History.
• Tap Add Lamp.
• Complete the fields in the Add Lamp dialog.
• Tap Save.
3. Tap and hold the green power button to turn the projector on.
4. Complete a LampLOC™ alignment on the new lamp:
• Tap Menu > Advanced Setup > LampLOC™ Setup.
• Tap Do Auto.
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)
Downloaded From projector-manual.com Christie Manuals
Do not connect a UPS directly to the projector UPS input.
Section 2: Installation and Setup
2-19