Connect The Cinema Projector To Ac Power With A Permanent Connection - Christie CP2220 Setup Manual

7. Install the lamp.

2.13 Connect the Cinema Projector to AC Power with a Permanent Connection

When connecting the cinema projector to AC power, follow all electrical codes for your location. In addition,
follow these recommendations:
• A 30-32A double pole, UL listed wall circuit breaker is required. It must be part of the building installation
and easily accessible.
• Use 10AWG or 8AWG wiring. The distance between the wall circuit breaker and the cinema projector must
not exceed 20 meters using 10AWG meters or 30 meters using 8AWG cables.
• For North American installations, use at least 10AWG copper wires for the connection of the main AC sup-
ply to the cinema projector's ground lug.
• Copper or aluminum are acceptable as conductor wiring material to the terminal block.
WARNING
safety. Never compromise safety by returning the current through the ground. 3) Connect
ground FIRST to reduce shock hazard.
the cable from rubbing against the cinema projector knockout plate and becoming damaged.
1. On the bottom of the cinema projector in the front right corner, loosen the two screws and slide the plate
forward to expose the terminal block.
CP2220 Setup Guide
020-100476-05 Rev. 1 (05-2014)
Anode
Yoke
Assembly
5mm hex key
required
Figure 2-10 Anode Yoke Posi-
1) Certified electrician required. 2) Ground (earth) connection is necessary for
Use an appropriate strain relief connector on the AC supply cable to prevent
Reflector
2-11