Front Master Cylinder Installation; Rear Master Cylinder Removal - Honda CR 125R 2002 Sevice Manual

HYDRAULIC BRAKE
INSTALLATION
Place the master cylinder assembly on the handlebar.
Align the end of the mast er cylinder with the punch
mark on the handlebar.
Install the master cylinder holder with the
~UP"
mark
facing up.
Tighten the upper bolt first, then the lower bolt.
TORQUE: 10 N·m 11.0 kgf.m, 7Ibf.ft)
Al ign the brake hose eyelet between the stoppers.
Install the brake hose eyelet with the oi l bolt and
new sealing washers.
Tighten the oil bolt to the specified torque.
TOROUE: 34 N ' m (3.5 kgf. m. 25 Ibf.ftl
Fi l l the reservoir to the upper level and bleed the
brake system (page 13-4),
REAR MASTER CYLINDER
13-12
REMOVAL
CAUTION
Avoid spilling fluid on painted, plastic, or rubber
parts. PllJcfI
II
rag over these parts whenevBr the
system ;s serviced.
NOTE:
When removing the brake hose bolt, cover the end
of the hose to prevent contamination. Secure the
hose to prevent fluid from leaking out.
Drain the brake hydrau lic system (page 13-4).
Remove the brake hose oil bolt, sealing washers and
brake hose.
Remove the rear master cylinder mounting bolts.
pw,eH MARK
~BOlT