Table of Contents
Advertisement
Honda CR125R
2004
OWNER'S MANUAL
All information in this publication is based on the latest product information available at the time of
approval for printing. Honda Motor Co., Ltd. reserves the right to make changes at any time without
notice and without incurring any obligation.
No part of this publication may be reproduced without written permission.
Honda Motor Co., Ltd. 2003
Advertisement
Table of Contents
Related Manuals for Honda CR125R 2004
Summary of Contents for Honda CR125R 2004
- Page 1 All information in this publication is based on the latest product information available at the time of approval for printing. Honda Motor Co., Ltd. reserves the right to make changes at any time without notice and without incurring any obligation.
- Page 2 FUEL TANK 7. Disconnect the fuel line from the fuel valve. MAINTENANCE PREPARATIONS The fuel line leading to the carburetor must be dis- Fuel Tank Removal SEAT connected, not the fuel line leading to the fuel tank. 1. Turn the fuel valve OFF. 8.
- Page 3 4. SERVICE AND MAINTENANCE Fuel Tank Installation 6. Install the shrouds, collars and tighten the shroud A SUBFRAME 1. Install the fuel tank on the frame. /B bolts. Subframe Removal 2. Connect the fuel line. 1. Remove the seat (page 17). 2.
- Page 4 4-stroke motorcycle engines. There are two classes: MA and MB. Use Pro Honda HP Trans Oil, Pro Honda GN4 or HP4 (without Oil conforming to the standard has the following clas- molybdenum additives) 4–stroke oil, or an equivalent.* sification on the oil container.
- Page 5 Coolant Recommendation NOTE: • Inspect the coolant level before each outing. A Use Pro Honda HP coolant or an equivalent high quality coolant loss of 0.7—2.0 US oz (20—60 cm , 0.7—2.1 ethylene glycol based anti-freeze containing corrosion lmp, oz) through the over flow tube is normal. If...
- Page 6 If you want to check the ignition Optional: If the electrodes appear burnt, or the insulator is white timing, refer to the Honda Service Manual. (NGK) BR9EV, or light gray (lean) or the electrodes and insulator are...
- Page 7 7. Allow the air cleaner to dry thoroughly. After dry- ing, soak the air cleaner in clean Pro Honda Foam Filter Oil or an equivalent air cleaner oil. Apply air cleaner oil to the entire surface, inner and outer, and rub it with both hands to saturate the air cleaner with oil.
- Page 8 4. SERVICE AND MAINTENANCE 10. Insert the pin in the air cleaner housing hole and CLUTCH Remove the five clutch spring bolts and clutch springs. install the assembly into the air cleaner housing Operation NOTE: while aligning the tab on the air cleaner and the •...
- Page 9 Rear Brake Pads DRIVE CHAIN Adjustment Inspect the pads visually from the rear side of the 1. Loosen the rear axle nut. Regular cleaning, lubrication, and proper adjustment caliper to determine the pad wear. If either pad is worn 2. Loosen the lock nuts and turn the adjusting bolt will help to extend the service life of the drive chain.
- Page 10 Put the transmission in gear, and then turn the rear used in preference to motor oil. Pro Honda Chain Lube wheel forward until the lower section of the chain is or an equivalent, or SAE 80 or 90 gear oil is recom- pulled taut.
- Page 11 DRIVEN SPROCKET DRIVE CHAIN SLIDERS DRIVE CHAIN ROLLERS Check the driven sprocket nut torque values after each 1. Check the chain slider for wear. Check the drive chain rollers for wear. Replace if neces- race. If the wear is 3/16 in (5 mm) or more, replace it. sary.