Reed Valve Disassembly/Assembly - Honda CR 125R 2002 Sevice Manual

FUEL SYSTEM
Aher 2001 :
Remove the reed valve, gasket, spacer and gasket.
4-22
Ch eck the reed valve for fatigue or damage and
replace the reed valve if necessary.
Check the reed valve stopper for cracks, damage
and clearance from the reed and replace the reed
valve stopper
if
necessary.
DISASSEMBLY/ASSEMBLY
Remove the screws , reed valve stopper and reed
valve .
Replace the reed valve after 3 races or about 7.5
hours.
Install the reed valve and reed valve stopper by
aligning the cut-oul in the reed valve and the cut-
out of the reed valve stopper.
Clean the screw threads.
Apply a small amount of locking agent to the tip of
the screw threads.
Tighten the screws to the specified torque.
TORQUE: 1 N-m 10.1 kgPm. 0.7 Ibfeft)
NOTE:
Do not apply a locking agent to the reed valve.
After installation, check for reed valve clearance.
SERVICE LIMIT: 0.2 mm (0.01 in)
VALVE
L1m:J
SCREW
L -
~
ALIGN
REED
0.2 mm (0.01 in)