Honda CR 125R 2002 Sevice Manual page 215

REAR WHEEL/SUSPENSION
If removed, install the rear brake caliper bracket onlo CALIPER
~RA(:KET
the slide rail of the swingarm.
Place the rear wheel into the swingarm.
Apply thin coat of grease to the axle.
Install the axle from the left side.
Install the drive chain over the driven sprocket .
If the master link retaining clip was removed, install
it
on the drive chain with the closed end of the
clip
in the direction of wheel rotation.
Install the adjusting block, washer and loosely install
the axle nut.
Adjust the drive chain slack (page 3-1
1).
Tighten the axle nut to the specified torque.
TORQUE : 127 N *m 113.0 kgf.m, 941bfoft)
Snug the adjusting bolts against the chain adjusters
and tighten the lock nuts.
. /
SLIDE RAIL
ADJUSTING BLOCK
,-
, . 1 ...
~
12-9